How do I reset BIOS to default?

Can you reset BIOS to default?

Resetting the BIOS



Once you’re in BIOS, you can try to hit either the F9 or F5 keys to bring up the Load Default Options prompt. Clicking Yes will be enough to restore the default settings. This key may be different depending on your BIOS, but it’ll usually be listed at the bottom of the screen.

How do I reset my BIOS settings?

[Motherboards] How can I restore BIOS settings?

  1. Press Power to turn on the motherboard.
  2. During POST, Press key to enter the BIOS.
  3. Go to Exit Tab.
  4. Select Load Optimized Defaults.
  5. Press Enter to default settings.

How do I reset my BIOS settings to default without display?

NEVER boot your system back up with the jumper on pins 2-3 NEVER! You must power down move the jumper to pins 2-3 wait a few seconds THEN move the jumper back to pins 1-2. When you boot up you can then go into the bios and select optimized defaults and change what ever settings you need from there.

What happens if I reset BIOS to default?

Resetting the BIOS configuration to the default values may require the settings for any added hardware devices to be reconfigured but will not affect the data stored on the computer.

What are default BIOS settings?

Your BIOS also contains a Load Setup Defaults or Load Optimized Defaults option. This option resets your BIOS to its factory-default settings, loading default settings optimized for your hardware.

How do I reset Uefi to default BIOS?

How do I reset my BIOS/UEFI to default settings?

  1. Press and hold the power button for 10 seconds, or until your system shuts completely down.
  2. Power on the system. …
  3. Press F9 and then Enter to load the default configuration.
  4. Press F10 and then Enter to save and exit.

How do I fix corrupted BIOS?

You can do this one of three ways:

  1. Boot into the BIOS and reset it to the factory settings. If you are able to boot into the BIOS, go ahead and do so. …
  2. Remove the CMOS battery from the motherboard. Unplug your computer and open your computer’s case to access the motherboard. …
  3. Reset the jumper.

How do I fix BIOS not booting?

If you cannot enter the BIOS setup during boot, follow these steps to clear the CMOS:

  1. Turn off all peripheral devices connected to the computer.
  2. Disconnect the power cord from the AC power source.
  3. Remove the computer cover.
  4. Find the battery on the board. …
  5. Wait one hour, then reconnect the battery.

Can I reset BIOS by removing CMOS battery?

Reset by removing and replacing the CMOS battery



Not every type of motherboard includes a CMOS battery, which provides a power supply so that motherboards can save BIOS settings. Bear in mind that when you remove and replace the CMOS battery, your BIOS will reset.

What causes BIOS to reset?

If bios always resets after a cold boot there is two reasons one the bios clock battery is dead. two on some mother boards have a bios clock jumper that is set to reset bios. those are what cause bios to reset on purpose. after that it could be a loose ram chip or a loose pci device.

How do I remove a BIOS password?

Reset BIOS Password

  1. Enter the BIOS password (case sensitive)
  2. Press F7 for Advanced Mode.
  3. Select the ‘Security’ tab and ‘Setup Administrator Password’
  4. Enter and confirm your new password, or leave this blank.
  5. Select the ‘Save & Exit’ tab.
  6. Select ‘Save Changes and Exit’, then confirm when prompted.
THIS IS IMPORTANT:  Your question: What is BIOS setup utility used for?
Operating system reviews