You asked: How do I reset my MSI BIOS to factory settings?

How do I reset my MSI BIOS?

Reset BIOS settings to default

  1. Press the power button to start the notebook. When MSI logo shows up, please keep tapping the “Delete” until you see the BIOS Setup Utility.
  2. After entering the BIOS menu, press “F9”. …
  3. Press “F10” key. …
  4. Notebook will be restart automatically.

Can you reset BIOS to factory settings?

Resetting the BIOS

Once you’re in BIOS, you can try to hit either the F9 or F5 keys to bring up the Load Default Options prompt. Clicking Yes will be enough to restore the default settings. This key may be different depending on your BIOS, but it’ll usually be listed at the bottom of the screen.

How do I fix a corrupted MSI BIOS?

Press CTRL + Home to trigger BIOS Recovery. -> The system should enter BIOS Recovery Routine. {Will basically work with both USB & PS/2 keyboard. However, a PS/2 Keyboard is recommended as the system will respond earlier to PS/2 Keyboard than to USB Devices.}

What is the BIOS key for MSI?

How to Get to BIOS on an MSI Motherboard

  • Restart the computer.
  • Press the “Delete” key while the system is booting up to enter the BIOS. There is normally a message similar to “Press Del to enter SETUP,” but it can flash by quickly. …
  • Change your BIOS configuration options as needed and press “Esc” when done.
THIS IS IMPORTANT:  What kind of file system does Unix have?

How do I factory reset my computer with command prompt?

The instructions are:

  1. Turn on the computer.
  2. Press and hold the F8 key.
  3. At the Advanced Boot Options screen, choose Safe Mode with Command Prompt.
  4. Press Enter.
  5. Log in as Administrator.
  6. When Command Prompt appears, type this command: rstrui.exe.
  7. Press Enter.
  8. Follow the wizard instructions to continue with System Restore.

How do I reset my BIOS without a monitor?

Use the power switch at the back of the computer to disconnect the motherboard temporarily. Turn on the computer for 2 seconds and shut it off again . Repeat this 4 times and then turn on your computer normally. Your BIOS will be at default settings.

How do you master reset a computer?

Navigate to Settings > Update & Security > Recovery. You should see a title that says “Reset this PC.” Click Get Started. You can either select Keep My Files or Remove Everything. The former resets your options to default and removes uninstalled apps, like browsers, but keeps your data intact.

How do I fix corrupted BIOS?

You can do this one of three ways:

  1. Boot into the BIOS and reset it to the factory settings. If you are able to boot into the BIOS, go ahead and do so. …
  2. Remove the CMOS battery from the motherboard. Unplug your computer and open your computer’s case to access the motherboard. …
  3. Reset the jumper.

What causes BIOS to corrupt?

A corrupted motherboard BIOS can occur for various reasons. The most common reason why it happens is due to a failed flash if a BIOS update was interrupted. … After you are able to boot into your operating system, you can then fix the corrupted BIOS by using the “Hot Flash” method.

THIS IS IMPORTANT:  How recover bad or brick BIOS Lenovo laptop?

How do I know if my BIOS is corrupted?

Symptoms. One of the most obvious signs of a corrupted BIOS is the absence of the POST screen. The POST screen is a status screen displayed after you power on the PC that shows basic information about the hardware, such as the processor type and speed, amount of installed memory and hard drive data.

Operating system reviews